BW June 2018

6/4: I practiced fusing today. For a while I was getting adequate strength but also wings. I would like to start fusing, though, and test a bundle to see if wings really matter. If we remove them and the fibers work, I think there is no reason to complain. If we run into problems with the first bundle, it won't be a major delay. We can cut off bad fuses and redo things.

I need a list of things to do next.

1. Ask Dr. Jones about the lips and why they would interfere with fusing.

2. Explain what happens during fusing in more detail.

3. Find out how to drain the Campbell Hausfeld compressor tank.

4. Start cleaning sci-fi bundles with the new lint-free cloths.

6/5: I'm not sure what is going on with the splicer.

By itself, it has often fused without creating wings, but the fuses are usually weak. They may hold 850 grams but break at 1050.

Usually if all I do is push down the top ferrule and push the long fiber to the right at the beginning of fusing, the gripping clamps do not bottom out. They often move partway to the right but do not bottom out.

Lips at the end of a fiber cause incomplete fusing if the splicer does all the work except for my two initial pushes. This is strange because the lips do not project beyond the end of the fiber.

If I push on the long fiber during heating and cooling, the gripping clamps are more likely to bottom out at some time. The results from my extra pushing are quite variable. Even if I push fairly hard, the fibers are sometimes weak and break at 850 grams, although they may have the kind of wings that used to imply adequate strength. However, pressing too hard creates huge wings that are too thick to cut easily. It is easy to damage the cladding while removing the thick wings.